Application
1. Clean glass is a must! Use ammonia or alcohol if needed. Avoid touching glass surface with your hands.
2. Remove the wax paper barrier before soaking.
3. With a good pair of small scissors trim about 1/16 inch away from the decal card
4. Curved-tip tweezers are very handy.
5. Wet the surface of the glass when applying the decal, it allows the decal to easily move into position.
6. To apply the decal, slide it slightly off of the paper and hold the paper edge with the tweezers. Position decal and hold exposed edge with finger, or a second pair of tweezers, on the glass while pulling paper from underneath. When the decal is in place hold with finder and blot excess water. Continue to gently blot, using an inside out rolling motion, until all the water and bubbles are out from underneath the decal, a small squeegee (credit card) is useful. Continue until the entire decal, including the edges, are firmly affixed to the clean glass surface.
7. Allow to dry completely before firing. The smallest amount of moisture can stream aprt the decal from the glass.
Firing Conditions
1. Over-firing is disappointment. Decal are temperature sensitive, some colors more than others. The best results are achieved with the lower temperatures and slightly longer soak times.
2. Good ventilation in the kiln during the burn off phase, (500-900f), is important for all decals and critical for hi-ire and low-fire ) accents) metallic decals. Leave the lid vented till the kiln reaches 1100f.
Info from Profusion Studio.
Application
1. Clean glass is a must! Use ammonia or alcohol if needed. Avoid touching glass surface with your hands.
2. Remove the wax paper barrier before soaking.
3. With a good pair of small scissors trim about 1/16 inch away from the decal card
4. Curved-tip tweezers are very handy.
5. Wet the surface of the glass when applying the decal, it allows the decal to easily move into position.
6. To apply the decal, slide it slightly off of the paper and hold the paper edge with the tweezers. Position decal and hold exposed edge with finger, or a second pair of tweezers, on the glass while pulling paper from underneath. When the decal is in place hold with finder and blot excess water. Continue to gently blot, using an inside out rolling motion, until all the water and bubbles are out from underneath the decal, a small squeegee (credit card) is useful. Continue until the entire decal, including the edges, are firmly affixed to the clean glass surface.
7. Allow to dry completely before firing. The smallest amount of moisture can stream aprt the decal from the glass.
Firing Conditions
1. Over-firing is disappointment. Decal are temperature sensitive, some colors more than others. The best results are achieved with the lower temperatures and slightly longer soak times.
2. Good ventilation in the kiln during the burn off phase, (500-900f), is important for all decals and critical for hi-ire and low-fire ) accents) metallic decals. Leave the lid vented till the kiln reaches 1100f.
Info from Profusion Studio.